Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Can anyone here explain how to remove the thermo sensor switch from the top of the head on a 92 wave 111. It has a retaining plate with 2 nuts and a grommet that is inserted into the head. I took off the plate and started pulling the grommet out but then stopped for fear its connected to something inside the head. Do I just yank that sob out or do i have to remove head cover and disconnect something inside. Dont want to destroy anything by just pulling. Also any tricks to getting the new one in. Thanks in advance.
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #3 ·
I see it but how does it come out.

Thanks for your responce. I see how it went in. Tight fit. How does it come out? I really dont want to have to pull the cylinder head cover to just remove a sensor. I pull on the wires and they of course just ripped right out. Sprayed wd into the hole, wont budge. Tried drilling a little hole for a slide hammer but the end of my slide wont grab. I even tried running the engine with out the retaining plate holding it in thinking maybe the compression would blow it out. Nothing. I guess i can jack with the slide hammer some more or tear it all apart again. Any tricks?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top