Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi guys,
Anyone recommend the best approach to take on replacing an stripped out engine /drive coupler on a Monte Carlo? Think its a `95. Should I remove the pump impleller/shaft to get at it? or remove the engine mounts and move the enigine forward... Sorry for the ignorance - but im used to kawasaki/yamaha's any help/hints/tips/pointers would be greatly appreciated. Looking for the easiest method... Thanks...
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #5 ·
Thanks for the suggestions. I took the engine route - accually easier than I thought it'd be. Just needed a long extention for the engine mount bolts (between/below the exhaust manifold), and a buddy to keep track of the shims and to help with moving the engine forward enough to get in the new coupler. Then lining it all back up and putting the shims back in place and bolts back in...
Bout a 1 hr job...

Thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top