Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi Everyone, I've been searching the internet and I can't figure this out....I have a Wave Blaster 1 and I just bought a blige pump and bracket (didn't come with instructions other than the wiring diagram) and I can't figure out where to put the bracket....when I opened up the hood I realized that it was alot tighter in there then I thought.

If you've done it before any advise would be great...thanks,

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.