Personal Water Craft Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
I got the motor on the bench and after a lot of trying I can't get the broken bolts out. I drilled the top bolt and used an easy out but I cranked pretty hard and didn't want to break it. Will heating this up work or do I have to drill and tap.


rhutson
 

·
Registered
Joined
·
23 Posts
I don't see why you can't apply some heat from a propane or MAP torch to the tab that sticks off the case that the bolt goes through. I don't know if I'd go at it with an oxy-acetylene torch though.

John
 
1 - 3 of 3 Posts
Top