Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
6 Posts
Discussion Starter · #1 ·
I have a 97 tigershark daytona 1000, I use a lazer temp gun,,,and after warming up the rear cyl gets 150deg, the center gets 120 and the mag cyl gets up to 180-190deg, is this temp diff normal? what temp do these machines overheat? The light/buzzer does not go off.

I was worried about it running lean so I just went threw all the carbs and replaced the fuel lines,, all is good there,,

any ideas?:eek:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.