Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
11 Posts
Discussion Starter · #1 ·
I am installing a primer on my buddy's kawi 750sx, and am wondering where to install the plunger. I usually drill out the choke hole on a kawi 550 or a yami 701, but the kawi 750sx has a funky side pull choke knob that turns, and there is no clearance inside for the plunger. Any ideas before I start drilling holes???
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.