Personal Water Craft Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I have a WR500Q 1992. The engine starts and runs fine. When I press the red stop button,it still runs. When I pull the lanyard, it still runs. Replaced the connections (plugs), still runs. I have to pull the choke and flood the engine to get it to shut off. Any suggestions.

Thanks in advance,

Jim
 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
Tried to purchase a used cdi on ebay but lost out on bid. Got frustrated with my search and brought it to a local repair shop. It was a blown fuse. $75 repair bill and I'm back on the water.
 

·
Registered
Joined
·
7 Posts
I bet the person who had it before you just eliminated the kill switches. I would take a better look at all the wireing in that area.
 

·
Registered
Joined
·
7 Posts
or if this is a new problem and you have had your ski for a while, It may very well be the switch unit itself. I doubt its the cdi causing the problem
 
1 - 7 of 7 Posts
Top