Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi guys,

Need some expert advice. 1990 X2 wont start when hot.

It'll start cold after cranking over for about 20 seconds but when hot, wont start at all

I changed the head gasket, carb, intake gasket, reed valves and spark plug.

It's geting air (choke can't be blocked- it is not installed)
Getting fuel (it runs cold an plugs are dark and smell like gas)
and making a good spark

Compression is 125 and 125

A friend suggested rectifier or air getting in through somewhere however the intake and head gaskets are new.

Anybody have any ideas or have seen this problem before??

Thanks!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top