Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
Just rebuilt my sbn 44 and struggled with replacing the grommets.. finally got them in along with the check valves but the valves don't seem to be 'sealing' around the metal circle of the pump body assembly... is this going to be a problem?
They look slightly concaved like a saucer where the grommet is pinching in the middle.
Also, whats the easiest way to remove/install the grommets in case i need to redo this part?

thanks guys
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.